Intel® Server System M50CYP1UR Family System Integration and Service Guide
108
Table 12. POST Error Messages and Handling
System RTC date/time not set
PCI component encountered a PERR error
PCI out of resources error
Enable Memory Mapped I/O above 4
GB item at SETUP to use 64-bit MMIO.
Processor core/thread count mismatch detected
Processor cache size mismatch detected
Processor family mismatch detected
Processor Intel(R) UPI link frequencies unable to
synchronize
Processor model mismatch detected
Processor frequencies unable to synchronize
BIOS Settings reset to default settings
Passwords cleared by jumper
Password clear jumper is Set
Recommend reminding user to install
BIOS password as BIOS admin
password is the master keys for
several BIOS security features.
CPU 0 unable to apply microcode update
CPU 1 unable to apply microcode update
CPU 0 failed Self-Test (BIST)
CPU 1 failed Self-Test (BIST)
CPU 0 microcode update not found
CPU 1 microcode update not found
Watchdog timer failed on last boot.
OS boot watchdog timer failure.
Baseboard Management Controller failed self-test.
Hot Swap Controller failure
Management Engine (ME) failed self-test.
Management Engine (ME) Failed to respond.
Baseboard management controller failed to respond
Baseboard Management Controller in Update Mode.
Baseboard Management Controller Sensor Data Record
empty.
Clear SEL through EWS or SELVIEW
utility.
Memory component could not be configured in the
selected RAS mode
Plug DIMM at right population.
PMem invalid DIMM population found on the system.
Populate valid POR PMem DIMM
population.
Memory failed test/initialization CPU0_DIMM_A1
Remove the disabled DIMM.
Memory failed test/initialization CPU0_DIMM_A2
Remove the disabled DIMM.
Memory failed test/initialization CPU0_DIMM_A3
Remove the disabled DIMM.