Intel® Server System M50CYP1UR Family System Integration and Service Guide
116
Appendix G. System Packaging Assembly Instructions
The original Intel packaging, in which the server system is delivered, is designed to provide protection to a
fully configured system and was tested to meet ISTA (International Safe Transit Association) Test Procedure
3A (2008). The packaging was also designed to be re-used for shipment after system integration has been
completed.
The original packaging includes two layers of boxes – an inner box and the outer shipping box, and various
protective inner packaging components. The boxes and packaging components are designed to function
together as a protective packaging system. When reused, all of the original packaging material must be used,
including both boxes and each inner packaging component. In addition, all inner packaging components
MUST be reinstalled in the proper location to ensure adequate protection of the system for subsequent
shipment.
Note: The design of the inner packaging components does not prevent improper placement within the
packaging assembly. There is only one correct packaging assembly that will allow the package to meet the
ISTA (International Safe Transit Association) Test Procedure 3A (2008) limits.
Failure to follow the specified packaging assembly instructions may result in damage to the system during
shipment.
1. Open the outer box (iPN K65051-001). Fold the flap slightly to avoid cracks on the corners. Place the
taped inner box (iPN K65084-001) into the outer box. See the following figure.
Caution: No cracks on the corners are permitted.
To Next Page
Loading...
Need help?
General
