Intel
®
Entry Server Chassis SC5299-E TPS Peripheral and Hard Drive Support
Revision 3.1
Intel order number D37594-005
109
The Intel
®
Entry Server Chassis SC5299-E is capable of accepting a single SAS hot swap
backplane hard drive enclosure in place of the fixed drive bay. Both backplanes (expanded and
non-expanded) have a connector to accommodate a SAF-TE controller on an add-in card. Each
backplane type supports up to six 1-in hot swap drives when mounted in the docking drive
carrier.
4.3.2 SAS Non-expander/Serial-ATA (SATA) Hot Swap Back Plane (HSBP)
The Intel
®
Entry Server Chassis SC5299-E 6HDD SATA HSBP is a monolithic printed circuit
board. The architecture is based on the QLogic* GEM424 enclosure management controller and
has support for up to six SATA drives.
The Intel
®
Entry Server Chassis SC5299-E 6HDD SATA HSBP supports the following feature
set:
QLogic* GEM424 enclosure management controller
External non-volatile SEEPROMs
Three I
2
C interfaces
SATA and SATA-II extension compatible
Compliance with SATA Accessed Fault Tolerant Enclosures (SAF-TE) specification,
version 1.00 and addendum
Compliance with Intelligent Platform Management Interface 1.5 (IPMI)
Support for up to six 1.5GHz SATA drives
Hot-swap drive support
Temperature sensor
FRU EEPROM
Two 4-pin standard hard drive power connectors
The following figure shows the functional blocks of the SATA HSBP:
To Next Page
Loading...
Need help?
General
