Chapter 3 — Use the Scanner
CN51 Mobile Computer User Manual 47
Codablock A Settings
This section lists all configurable settings for decoding the Codablock
A symbology.
Codabar Length Mode Settings and Descriptions
Setting Description
Mode Sets the length mode for Codabar decoding.
Options include:
• Length 1 minimum (default)
• Lengths 1,2,3 fixed
• Length 1 minimum, length 2 maximum
Length 1 Restricts the length of the bar code that the scanner
will read. Range is 0 to 255. Default is 6.
Length 2 Restricts the length of the bar code that the scanner
will read. Range is 0 to 255. Default is 0.
Length 3 Restricts the length of the bar code that the scanner
will read. Range is 0 to 255. Default is 0.
Codablock A Settings and Descriptions
Setting Description
User defined symbology ID Sets the symbology ID for Codablock A.
Range is 1 to 4 ASCII characters. \xFF is
not supported.
Default is K0.
Code mark A one-character code mark that serves as
an identifier for Codablock A.
Default is *.
To Next Page
Loading...
