Chapter 3 — Use the Scanner
62 CN51 Mobile Computer User Manual
Japan Post Settings
This section lists all the configurable settings for decoding the Japan
Post symbology.
Code mark A one-character code mark that serves as an
identifier for Interleaved 2 of 5.
Default is I.
Interleaved 2 of 5 Length Mode Settings and Descriptions
Setting Description
Mode Sets the length mode for Interleaved 2 of 5 decoding. Options
include:
• Length 1 minimum (default)
• Lengths 1,2,3 fixed
• Length 1 minimum, length 2 maximum
Length 1 Restricts the length of the bar code that the scanner will read.
Range is 0 to 255. Default is 6.
Length 2 Restricts the length of the bar code that the scanner will read.
Range is 0 to 255. Default is 0.
Length 3 Restricts the length of the bar code that the scanner will read.
Range is 0 to 255. Default is 0.
Japan Post Settings and Descriptions
Setting Description
Transmit check digit Enables or disables transmission of the
check digit as part of the bar code data.
Default is disabled.
User defined symbology ID Sets the symbology ID for Japan Post.
Range is 1 to 4 ASCII characters. \xFF is
not supported.
Default is P5.
Interleaved 2 of 5 Settings and Descriptions (Continued)
Setting Description
To Next Page
Loading...
