Chapter 3 — Use the Scanner
76 CN51 Mobile Computer User Manual
Set the Scanner Trigger or Aimer Mode
You use the Settings app to set the trigger and aimer modes for the
scanner. You can also select how the imager behaves after a good read.
1 Start the Settings app and tap Scanners > Internal Scanner >
Scanner Settings. Hardware triggering is enabled by default.
2 Tap a setting in the list to change it. Your changes are
automatically saved.
Scanner Settings
This section lists the configurable trigger and aimer mode settings.
Note: For these settings, pressing the Scan button on the computer is
the same as pulling the trigger on the scan handle accessory.
Trigger and Aimer Mode Settings
Setting Description
Hardware
trigger
Enables or disables the scanner (or an external scanning device)
without affecting communication to the computer. When
disabled, nothing happens when you press the Scan button. For
tethered scanners, the laser or imager beam may turn on, but no
data is read.
Default is enabled.
To Next Page
Loading...
