Chapter 3 — Use the Scanner
CN51 Mobile Computer User Manual 77
Trigger
mode
Sets the behavior of the scanner when you press the Scan button:
• Level (default): The scanner turns on and stays on until you
release the Scan button.
• Pulse: The scanner turns on and stays on until the end of the
trigger timeout.
• Flashing: The scanner turns on and stays on while looking for
a bar code to read. At the end of the trigger timeout, the beam
starts flashing. When the scanner reads a bar code, it restarts
the trigger timeout. If you press the Scan button again, the
scanner turns off.
• Autostand: Switches between Level and Flashing modes. The
first time you press the Scan button, the scanner turns on in
Flashing mode. To switch to Level mode, press the Scan
button again.
• Toggle: The scanner turns on and stays on, and does not read
a bar code until you release the Scan button.
Aimer
mode
Enables or disables the aimer activation feature. Options include:
• Typical aimer
• One pull aim and read
• One pull aim, second pull read
Turn off
after
good read
Defines how the scanner operates when you press Scan to read a
bar code. Options include:
• Disable/Auto-trigger: Press Scan once to scan a series of bar
codes. When you release the Scan button, the scanner turns
off. To scan the same bar code more than once, you must
release the button, read a different bar code before trying a
second read, or wait until the identical consecutive timeout is
over.
• Enable/One-shot: You must press Scan each time you want to
read a bar code. After the read, the scanner turns off.
Trigger and Aimer Mode Settings (Continued)
Setting Description
To Next Page
Loading...
