Intermec CN51 - Dutch Post Settings; EAN;UPC Settings

Chapter 3 — Use the Scanner
54 CN51 Mobile Computer User Manual
Dutch Post Settings
This section lists all configurable settings for decoding the Dutch Post
symbology.
EAN/UPC Settings
This section lists the configurable settings for decoding the EAN/UPC
symbology.
Dutch Post Settings and Descriptions
Setting Description
User defined symbology ID Sets the symbology ID for Dutch Post.
Range is 1 to 4 ASCII characters. \xFF is
not supported.
Default is P4.
Code mark A one-character code mark that serves as
an identifier for Dutch Post.
Default is *.
EAN/UPC Settings and Descriptions
Setting Description
UPC-A Enables or disables UPC-A decoding. Default is
enabled.
UPC-E Enables or disables UPC-E decoding. Default is
enabled.
EAN-8 Enables or disables EAN-8 decoding. Default is
enabled.
EAN-13 Enables or disables EAN-13 decoding. Default is
enabled.
UPC-E1 Enables or disables UPC-E1 decoding. Default is
disabled.
Add-on digits Sets whether or not add-on digits must be present in
the bar code. Options include:
• Transmit if found (default): The scanner reads all
bar codes.
• Controlled by add-on digits: The scanner reads
the bar code only if add-on digits are present.