Intermec CN51 - Page 69

Chapter 3 — Use the Scanner
CN51 Mobile Computer User Manual 55
Add-on 2 digits active Enables or disables transmission of the two-digit
add-on (when present). Default is disabled.
Add-on 5 digits active Enables or disables transmission of the five-digit
add-on (when present). Default is disabled.
Add-on security Value that increases the odds that the scanner will
read add-on digits encoded in the bar code. Range is
0 to 100.
Default is 10. Setting this parameter to 100 (the
highest value) does not guarantee that the imager
will read the add-on digits.
Reading range Sets the reading range. Options include:
• Normal
• Extended (default)
Transmit UPC-A as
EAN-13
Enables or disables transmission of UPC-A as
EAN-13. Default is disabled.
Transmit UPC-E as
UPC-A
Enables or disables transmission of UPC-E as
UPC-A. Default is disabled.
Transmit EAN-8 as
EAN-13
Enables or disables transmission of EAN-8 as
EAN-13. Default is disabled.
GTIN compliant Enables or disables GTIN compliance. Default is
disabled.
UPC-A
UPC-A Options
Setting Description
Number system
transmission
Enables or disables transmission of the UPC-A
number system character. Default is enabled.
Check digit Enables or disables reading the check digit. Default
is enabled.
User defined
symbology ID
Sets the symbology ID for UPC-A. Range is 1 to 4
ASCII characters. \xFF is not supported.
Default is A0.
Code mark A one-character code mark that serves as an
identifier for UPC-A. Default is A.
EAN/UPC Settings and Descriptions (Continued)
Setting Description