Chapter 3 — Use the Scanner
72 CN51 Mobile Computer User Manual
TLC 39 Settings
This section lists all the configurable settings for decoding the TLC 39
symbology.
User defined symbology ID Sets the symbology ID for Telepen. Range
is 1 to 4 ASCII characters. \xFF is not
supported.
Default is C6.
Code mark A one-character code mark that serves as
an identifier for telepen.
Default is *.
Telepen Length Mode Settings and Descriptions
Setting Description
Mode Sets the length mode for Telepen decoding. Options
include:
• Length 1 minimum (default)
• Lengths 1,2,3 fixed
• Length 1 minimum, length 2 maximum
Length 1 Restricts the length of the bar code that the scanner
will read. Range is 0 to 255. Default is 0.
Length 2 Restricts the length of the bar code that the scanner
will read. Range is 0 to 255. Default is 0.
Length 3 Restricts the length of the bar code that the scanner
will read. Range is 0 to 255. Default is 0.
TLC 39 Settings and Descriptions
Setting Description
Linear only transmit mode Enables or disables linear only transmit
mode. When enabled, the computer only
transmits the linear part of the bar code.
Default is disabled.
Telepen Settings and Descriptions (Continued)
Setting Description
To Next Page
Loading...
