Intermec EasyCoder 501 E User Manual

Intermec EasyCoder 501 E – Installation & Operation Ed. 1 127
Appendix 2 Media Specifi cations
Media Roll Size
Core
Diameters: 38-40 mm (1.5 inches) or 76.2 mm (3 inches)
Width: Must not protrude outside the media.
The media must be wound up on the core in such a way that the
printer can pull the end free.
Roll
Max. diameter (internal roll): 205 mm (8.00 inches)
Max. width: 120 mm (4.72 inches)
Min. width: 25.4 mm (1.00 inches)
Max. web thickness: 175 µm (0.007 inches)
The maximum recommended media thickness is 175µm. Thicker
media may be used, but print quality will be reduced. The stiffness
is also important and must be balanced against thickness to maintain
print quality.
Caution!
Any external media supply should be well protected against sand,
grit, etc. Even very small but hard particles may cause severe
harm to the printhead.
Width:
Max. 120.0 mm (4.7 in)
Min. 25.4 mm (1.0 in)
Printable
side
or
label
s
Core diameter:
38-40 mm (1.5 in
-1.6 in)
or
76.2 mm
(3 in)
Roll diameter:
Max. 205 mm (8 in)

Intermec EasyCoder 501 E Specifications

General

Brand	Intermec
Model	EasyCoder 501 E
Category	Label Maker
Language	English