Intermec EasyCoder 501 E - Entering Setup Mode at Installation

Intermec EasyCoder 501 E – Installation & Operation Ed. 172
Chapter 8 Setup Mode
The method of entering the Setup Mode depends on which startup
fi les are stored in the printer’s memory, a subject that was more
thoroughly discussed in Chapter 4, “Starting Up.”
EasyCoder 501 E with Intermec Shell:
• Switch on the power.
• When the display shows the message “Enter=Intermec Shell;
x sec.”, press <Enter>.
• Press the <Setup> key (this facility can be used anywhere within
Intermec Shell Enhanced).
• Set up the printer as described in this chapter.
• Return to Intermec Shell Enhanced by pressing the <Setup>
key.
EasyCoder 501 E with no startup fi le installed:
• Switch on the power.
• In the immediate mode of Intermec Fingerprint, press the
<Setup> key.
• Set up the printer as described in this chapter.
• Return to the immediate mode of Intermec Fingerprint by
pressing the <Setup> key.
EasyCoder 501 E with a custom-made application program:
• Normally, there will be no need to enter the Setup Mode
for custom-made application programs. Necessary provisions
for changing the setup, manually or automatically, should be
provided by the program.
Entering
Setup Mode
at Installation