Intermec EasyCoder 501 E - Exiting Terminal Setup

Intermec EasyCoder 501 E – Installation & Operation Ed. 186
Chapter 9 Intermec Shell Startup Program
To exit the Terminal Setup program, step through all the facility
options and select Reboot, as illustrated below:
----------------
SHELL
PRINT SETUP
----------------
(Y / N / B):N
----------------
SHELL
TESTFEED
----------------
(Y / N / B):N
----------------
SHELL
TEST LABEL
----------------
(Y / N / B):N
----------------
SHELL
FONT SCALING
----------------
(Y / N / B):N
----------------
SHELL
SER-COM RESET
----------------
(Y / N / B):N
----------------
SHELL
CLEAR RAM MEMORY
----------------
(Y / N / B):N
----------------
SHELL
REBOOT
----------------
(Y / N / B):Y
Terminal Setup, cont.
Exiting Terminal Setup
If you answer N (=No) at the
Shell Reboot prompt, you will
return to the “Select Applica-
tion” option, but if you answer
Y (=Yes) the printer will start
up again and begin the Intermec
Shell countdown. Then you can
enter Terminal Setup once more
by transmitting a triple T, enter
the Intermec Shell manually
by pressing <Enter> in the
countdown menus, or return to
the last selected application by
waiting for the countdown to be
completed without taking any
action.