Intermec EasyCoder 501 E User Manual

Intermec EasyCoder 501 E – Installation & Operation Ed. 1 71
Chapter 8
Setup Mode
Setting Up
EasyCoder 501 E
EasyCoder 501 E (Enhanced) isintended for applications, where the
printer not only can be controlled from a host computer, but also to
some extent from the its built-in membrane-switch keyboard.
To allow full fl exibility, each key is programmable and the keyboard
can be remapped.
Keys, that are not used, can be disabled and the beep signal, that
usually acknowledges a key being activated, can be turned off.
Please refer to the Intermec Fingerprint v6.14, Reference Manual,
statements KEY ON/OFF, ON KEY GOSUB, and KEY BEEP
for further information.
EasyCoder 501 E can be set up using setup fi les and setup strings
(see SETUP statement in the Intermec Fingerprint v6.14, Reference
Manual or in the Intermec Direct Protocol v6.13, Programmer’s
Guide), but is also provided with a Setup Mode which allows
it to be set up in regard of all parameters using its own built-in
keyboard. The Setup Mode can be accessed via the Intermec Shell
Enhanced program, by the issuing of the Intermec Fingerprint
statement SETUP, or by pressing the <Setup> key in the Intermec
Fingerprint’s immediate mode.

Intermec EasyCoder 501 E Specifications

General

Brand	Intermec
Model	EasyCoder 501 E
Category	Label Maker
Language	English