Intermec EasyCoder 501 E User Manual

Intermec EasyCoder 501 E – Installation & Operation Ed. 18
Chapter 1 Introduction
Safety Require-
ments
Product Labeling
The following manuals may also be of interest to the operator
or programmer:
• Intermec EasyCoder 501 E, User’s Guide (multi-lingual)
• Intermec Direct Protocol v6.13, Programmer’s Guide
• Intermec Fingerprint v6.13, Programmer’s Guide
• Intermec Fingerprint v6.14, Reference Manual
• Intermec LabelShop, various manuals
Intermec assumes no responsibility regarding the CE Directive if
the printer is handled, modifi ed, or installed in any way other than
that described in Intermec’s manuals.
Caution
• Read this manual carefully before connecting the printer.
• Moving parts are exposed when the side door is open, so ensure
that the door is closed before you operate the printer.
• Do not open the front/left-hand cover. Dangerous voltage!
• Do not remove the bottom plate. Dangerous voltage!
• Do not put your fi ngers inside the print mechanism when
the power is on.
• Place the printer on an even surface which can support its weight
of approximately 15 kg (33 pounds) plus supplies.
• Do not spray the printer with water. If you are using a hose to clean
the premises in an industrial environment, remove the printer or
protect it carefully from spray and moisture.
• Carefully read the warning text on the envelope before using
a cleaning card.
The machine label is attached to the printer’s rear plate and contains
information on type, model, and serial number as well as AC voltage.
It also contains various signs of approval.
Supplementing
Manuals

Intermec EasyCoder 501 E Specifications

General

Brand	Intermec
Model	EasyCoder 501 E
Category	Label Maker
Language	English