Intermec EasyCoder 501 E User Manual

Intermec EasyCoder 501 E – Installation & Operation Ed. 1 53
Chapter 7 Setting Up the Printer
Default Setup
The printer’s default setup with standard confi guration EPROMs
is listed below:
Contrast Middle (5)
Ser-Com ("uart1:") Baud rate: 9600
Parity: none
Character length: 7 bits
Stop bits: 2 bits
RTS/CTS: Disable
ENQ/ACK: Disable
XON/XOFF, data to host: Enable
XON/XOFF, data from host: Enable
New line: CR/LF
Detection Feedadjust:
Startadjust: 0
Stopadjust: 0
Service Media Size:
X-start (8 /11.81 dots per mm): 0/0
Width (8 /11.81 dots per mm): 832/1280
Length (8 /11.81 dots per mm): 1200/1200
Media type: Label (w Gaps)
Print defs:
Paper type (thermal transfer printers): UBI HP 20
Paper type (direct thermal printers): RICOH 130LAB/LAM
Performance: Normal
Memory alloc:
Image buffer size: 48 Kbytes
Receive buffer: 300 bytes
Transmit buffer: 300 bytes
The printer’s current setup values can be read from the printer’s
display window by browsing through the Setup Mode, or from the
host by browsing through the Terminal Setup of Intermec Shell.
You can list the printer’s current setup values by printing test label
#5 in the Setup Mode or by using Intermec Shell. The current setup
values can be sent to the host via the standard serial communication
channel using a SETUP WRITE "uart1:" statement (see Intermec
Fingerprint v6.14, Reference Manual).
Reading the
Current Setup

Intermec EasyCoder 501 E Specifications

General

Brand	Intermec
Model	EasyCoder 501 E
Category	Label Maker
Language	English