Intermec EasyCoder 501 E User Manual

Intermec EasyCoder 501 E – Installation & Operation Ed. 1 75
Chapter 8 Setup Mode
Setup Mode Overview, Part 2 Intermec Fingerprint v6.14
VAR LENGTH STRIP
FIX LENGTH STRIP
TICKET (w GAPS)
TICKET (w MARK)
SETUP:
SERVICE
SETUP:
PASSWD:
SERVICE:
MEDIA SIZE
A series of test labels is printed in a loop.
If printer is unable to print a test label, press F5
for a status report.
Enter the 13-digit code number of the new
supply).
• Press F4 to return to the “Detection” menu in part 1.
• Press F5 key to return to “Media Size” menu.
• Press Setup to exit the Setup Mode.
MEDIA SIZE:
XSTART
XSTART:
[0]:
MEDIA SIZE:
WIDTH
WIDTH:
[832]:
MEDIA SIZE:
LENGTH
LENGTH:
[1200]:
SERVICE:
MEDIA TYPE
MEDIA TYPE:
LABEL (w GAPS)
SERVICE:
PRINT DEFS
PRINT DEFS:
HEAD RESIST
HEAD RESIST:
[nnn]: Measured
PRINT DEFS:
PAPER TYPE
(designation)
(designation)
PAPER TYPE:
(designation)
PRINT DEFS:
TESTPRINT
<PRINT> = PRINT
<C> = EXIT
ULTRA HIGH
HIGH
SERVICE:
PERFORMANCE
PERFORMANCE:
NORMAL
SERVICE:
MEMORY ALLOC
MEMORY ALLOC:
IMAGE BUFF SIZE
IMAGE BUFF SIZE:
[48Kb]:
PRINT DEFS:
NEW SUPPLIES
NEW SUPPLIES:
#
MEMORY ALLOC:
REC BUF UART1
REC BUF UART1:
[300]:
MEMORY ALLOC:
TRANS BUF UART1
TRANS BUF UART1:
[300]:
MEMORY ALLOC:
REC BUF UART2
REC BUF UART2:
[300]:
MEMORY ALLOC:
TRANS BUF UART2
TRANS BUF UART2:
[300]:
MEMORY ALLOC:
REC BUF UART3
REC BUF UART3:
[300]:
MEMORY ALLOC:
TRANS BUF UART3
TRANS BUF UART3:
[300]:
Enter password:
1138
Value is read-only
Printhead resistance is set automatically at start-up.
Depending on model, various paper type
designations are displayed. New setup options
can be added using the "New Supplies" menu,
see below.
These menus are only displayed if an optional
interface board with at least one serial
communication channel is installed.
Enter
Enter
Enter

Intermec EasyCoder 501 E Specifications

General

Brand	Intermec
Model	EasyCoder 501 E
Category	Label Maker
Language	English