Intermec ScanPlus 1800 Installation Manual

6. Operating settings trigger activation
120 ScanPlus 1800 - Installation Manual
trigger activation
- LASER SAFETY: the ScanPlus 1800 ST is a Class 2 Laser product - CAUTION - LASER
LIGHT WHEN OPEN. DO NOT STARE INTO BEAM.
- for laser and ccd trigger models
standard mode with aiming beam energy saver mode
ccd ccd ccd
laser --- laser
- "trigger not active" = default for ccd trigger models
- "standard mode - active while trigger pressed, standby after good read" = default for laser
models
- activating trigger options deactivates autostand mode and flashing mode
- IMPORTANT : your ScanPlus will stop working if you :
- use trigger commands with non-trigger models
- activate energy saver mode without the special energy saver cable
- connect a non-energy saver cable to a ScanPlus with energy saver activated
- if this happens :
1. disconnect the ScanPlus
2. keep the trigger pressed (if applicable) and connect the ScanPlus over a "reset factory
defaults" configuration code (read from setup sheet, Getting Started Guide or Installation
Manual)
trigger not active (*)
\45\5D\00\60
- (*) default setting for ccd trigger models
- laser beam always on if "trigger not active" for laser models
- LASER SAFETY: the ScanPlus 1800 ST is a Class 2 Laser product -
CAUTION - LASER LIGHT WHEN OPEN. DO NOT STARE INTO
BEAM.

Intermec ScanPlus 1800 Specifications

General

Brand	Intermec
Model	ScanPlus 1800
Category	Barcode Reader
Language	English