6. Operating settings flashing mode
126
ScanPlus 1800 - Installation Manual
flashing mode
- LASER SAFETY: the ScanPlus 1800 ST is a Class 2 Laser product - CAUTION - LASER
LIGHT WHEN OPEN. DO NOT STARE INTO BEAM.
- for laser and ccd models
- activating flashing mode deactivates trigger options and autostand mode
- LED economizer flash during standby (changes to continuous beam when a bar code is
presented)
flash after 10 minutes (*)
\47\42\47\4F\47\51\0A\60
- (*) default setting for ccd models ("no flash" is
the default setting for laser models)
no flash (*)
\47\43\47\51\00\60
- (*) default setting for laser models ("flash after 10
minutes" is the default setting for ccd models)
compose time-out before flash (min): [range: 1-60 min]
\47\42\47\4F\47\51\60
- enter a number string and scan End Selection
(Appendix C)
To Next Page
Loading...
Need help?
General
