4. Data transmission settings RS-232
ScanPlus 1800 - Installation Manual
53
compose delay before RTS idle (ms): [range: 0-2500 ms]
\47\5E\60
- enter a number string and scan End Selection
(Appendix C)
- default = 10 ms
- delay for RTS idle after each character / idle
after whole message
- not valid for RTS pulse on each character
preamble
[preamble] [symbology id] <data> [postamble]
none (*)
\45\53\3E\00\60
compose:
\45\53\60
- enter an ASCII string and scan End Selection
(Appendix A)
- maximum = 20 characters
preamble / postamble
[preamble] [symbology id] <data> [postamble]
STX / ETX
\45\53\3E\02\45\54\3E\03\60
To Next Page
Loading...
Need help?
General
