To Next Page

To Previous Page

6. Operating settings autostand mode

ScanPlus 1800 - Installation Manual

127

autostand mode

- LASER SAFETY: the ScanPlus 1800 ST is a Class 2 Laser product - CAUTION - LASER

LIGHT WHEN OPEN. DO NOT STARE INTO BEAM.

- for laser and ccd trigger models used for automatic "hands-free" scanning with raised stand 0-

360029-00 for example (they can still be picked up and used manually !)

- automatic autostand operation :

- laser trigger models : half-speed laser economizer beam during automatic standby

- ccd trigger models : LED economizer flash during automatic standby

- all models change to continuous beam when a bar code is presented and are active for the

specified activation cycle duration (default = 10 sec)

- each good read within the activation cycle duration starts a new activation cycle

- if there is no good read before the end of the activation cycle duration, the ScanPlus 1800

returns to automatic standby

- after 1 hour of inactivity (no reads), the ScanPlus 1800 goes into full automatic standby (no

reading light or read function, green LED blinks slowly): press the trigger to return to normal

automatic autostand operation

- manual autostand operation :

- pressing the trigger one time puts the ScanPlus 1800 into manual standby for the specified

activation cycle duration (default = 10 sec)

- during manual standby, the reading light and read function are switched off

- pressing the trigger before the end of the activation cycle duration activates the read

function (active while trigger pressed, standby after good read)

- releasing the trigger starts a new manual standby cycle

- if the trigger is not pressed again before the end of the activation cycle duration, the

ScanPlus 1800 returns to automatic autostand operation

- a rapid double-click on the trigger returns the ScanPlus 1800 immediately to automatic

autostand operation (does not wait until the end of the activation cycle duration)

active for activation cycle duration (10 s), repeat activation cycle after good read

\4C\40\01\47\50\46\4D\47\51\0A\60

- activating autostand mode deactivates other

trigger options and flashing mode

Intermec ScanPlus 1800 Installation Manual

Other manuals for Intermec ScanPlus 1800