31
6.2 REM24 remote: Error codes and diagnostic codes
The drive electronics can automatically rectify some faults. In this case the status display will stop
blinking. Switch the remote on and off again several times. Wait around 5 seconds each time
before switching the remote on again. If this does not rectify the fault, determine the cause using
the blink codes from the following table.
Blink Code Possible Cause Solution Documentation
1 x blink
Module defective Replace defective
module
See chapter 7.2.9.
2 x blink
Accessory error (e.g.
short-circuit in adjusting
motor)
Check accessory
connections, check
accessory
See chapter 7.17.
Lifter too high or too low
(seat not at driving
height)
If the lifter is raised, lower
it slowly until the status
display stops blinking. If
the lifter is too low, raise
it slowly until the status
display stops blinking.
Only drive when the seat
is at driving height.
See operating
manual
3 x blink
Error at right-hand motor
Connection
loose/defective or motor
defective
Check connection plug,
check motor
See chapters 7.9
and 7.2
4 x blink
Error at left-hand motor
Connection
loose/defective or motor
defective
Check connection plug,
check motor
See chapters 7.9
and 7.2
5 x blink
Fault/brake fault on right-
hand motor. Connection
loose/defective or motor
defective
Check connection plug See chapters 7.9
and 7.2
6 x blink
Fault/brake fault on left-
hand motor. Connection
loose/defective or motor
defective
Check connection plug See chapters 7.9
and 7.2
7 x blink
Completely discharge
battery
Pre-charge battery See operating
manual
8 x blink
Battery voltage too high Switch lighting to low
battery voltage
Check battery charger
See charging unit
operating manual
9 or 10 x blink
Faulty data transmission
between modules
Remove electronic
modules except for the
power module and the
remote. Replace the
modules one after
another in order to
ensure which the one
was causing the fault.
See chapter 7.2.9.
To Next Page
Loading...
