System Commands
Copyright© Itech Electronic Co., Ltd. 88
Query syntax
*STB?
Arguments
None
Returns
<value>
Related Command
*CLS *ESE *ESR
*TRG
When the trigger mode of the power supply is BUS order trigger mode, the order
will Generates a trigger signal. The function is the same as
TRIGger[:TRANsient][:IMMediate]
Command syntax
*TRG
Arguments
None
Related Command
TRIG TRIG:SOUR
*TST?
This command is used to query the self-test by the instrument. 0 indicates that
self-test succeeds; other Arguments indicate self-test fails. In addition, in case
of failure, an error information will be generated to describe failure reason.
Query syntax
*TST?
Arguments
None
Returns
<NR1>
*WAI
This command instructs the power supply not to process any further commands
until all pending operations are completed.Pending operations are as defined
To Next Page
Loading...
