System Commands
Copyright© Itech Electronic Co., Ltd. 33
Chapter4 Vector Commands
Under the three-phase mode, use vector commands. However, IT7626
programmable AC power supply has no vector commands.
VECTor:ORDEr
This command is used to set the vector order.
Command syntax
VECTor:ORDEr <value>
Arguments
<value> order.
Query syntax
VECTor:ORDEr?
Returns
<value>
VECTor:DATA?
This command is used to obtain the vector data to which the current order
corresponds.
A: rms
A: phase
B:rms
B:phase
C:rms
C:phase
Command syntax
VECTor:DATA?
Arguments
None
Returns
<float>,…,<float> 6 floats
To Next Page
Loading...
