ITech IT7600 Series

System Commands
Copyright© Itech Electronic Co., Ltd. 73
PROTect:RMS:CTR?
This command is used to query the control mode of RMS protection current.
Command syntax
PROTect:RMS:CTR? <PARAllel|THREephase>
Arguments
Parameter 1：Device working mode
PARA, THREephase
Returns
<IMME|TIME>
PROTect:PEAK:CURRent
This command is used to set the peak protection current.
Command syntax
PROTect:PEAK:CURRent <PARAllel|THREephase>,<float>
Arguments
Parameter 1：Device working mode
PARA,THREephase
Parameter 2：Current peak
Query syntax
PROTect:PEAK:CURRent? <PARAllel|THREephase>
Returns
<float>
PROTect:PEAK:CURRent?
This command is used to query the peak protection current.
Command syntax
PROTect:PEAK:CURRent? <PARAllel|THREephase>
Arguments
Parameter 1：Device working mode
PARA, THREephase