ITech IT7600 Series

System Commands
Copyright© Itech Electronic Co., Ltd. 40
Returns
POS|NEG|ANY
WAVE:TRIGger:SLOPe?
This command is used to query trigger slope when takes waveform as trigger
source.
Command syntax
WAVE:TRIGger:SLOPe?
Arguments
None
WAVE:TRIGger:SOURce
This command can set or read the device taking which kind waveform as trigger
source.
Command syntax
WAVE:TRIGger:SOURce <VOLTage|CURRent>
Arguments
VOLTage|CURRent
Query syntax
WAVE:TRIGger:SOURce?
Returns
VOLT|CURR
WAVE:TRIGger:SOURce?
This command can query the device taking which kind waveform as trigger
source.
Command syntax
WAVE:TRIGger:SOURce?
Arguments
None
WAVE:TRIGger:VOLTage[:LEVel]
This command is used to set the voltage trigger level.