To Next Page

To Previous Page

Remote Control

can use upper or lower, for example:

*RST = *rst

:DATA? = :data?

:SYSTem:PRESet = :system:preset

Long-Form and Short-Form Versions

A SCPI command word can be sent in its long-form or short-form version.

However, the short-form version is indicated by upper case characters.

Examples:

:SYSTem:PRESet long-form

:SYST:PRES short form

:SYSTem:PRES long-form and short-form combination

Note that each command word must be in long-form or short-form, and

not something in between.

For example, :SYSTe:PRESe is illegal and will generate an error. The

command will not be executed.

Query

Observe the following precautions with queries:

⚫ Set up the proper number of variables for the returned data. For example,

if you are reading back a measurement array, you must dimension the

array according to the number of measurements that you have placed in

the measurement buffer.

⚫ Read back all the results of a query before sending another command to

the instrument. Otherwise a Query Interrupted error will occur and the

unreturned data will be lost.

1.3 Message Type of SCPI

There are two types of SCPI messages, program and response.

⚫ Program message: A program message consists of one or more properly

formatted SCPI commands sent from the controller to the instrument. The

message, which may be sent at any time, requests the instrument to

perform some action.

⚫ Response message: A response message consists of data in a specific

SCPI format sent from the instrument to the controller. The instrument sends

the message only when commanded by a program message called a

"query."

The next figure illustrates SCPI message structure:

ITech IT7600 Series User Manual

Questions and Answers: