ITech IT7600 Series

System Commands
Copyright© Itech Electronic Co., Ltd. 60
Command syntax
[SOURce:]NORMal:PHASe:STARt[:LEVel][:IMMediate]
<A>,<float>
Arguments
<A>
<float> the starting angle
Query syntax
[SOURce:]NORMal:PHASe:STARt[:LEVel][:IMMediate]? <A>
Returns
<float>
[SOURce:]NORMal:PHASe:STARt:LIMit[:LEVel]
This command is used to set the maximum and minimum starting angle of a
phase.
Command syntax
[SOURce:]NORMal:PHASe:STARt:LIMit[:LEVel]
<A>,<MINimum|MAXimum>,<float>
Arguments
<A>
<MINimum|MAXimum>
<float>
Query syntax
[SOURce:]NORMal:PHASe:STARt:LIMit[:LEVel]?
<A>,< MINimum|MAXimum >
Returns
<float>
[SOURce:]NORMal:PHASe:STOP[:LEVel][:IMMediate]
This command is used to set the stopping angle of a phase.
Command syntax
[SOURce:]NORMal:PHASe:STOP[:LEVel][:IMMediate]
<A>,<float>