ITech IT7600 Series

System Commands
Copyright© Itech Electronic Co., Ltd. 39
Chapter6 Oscilloscope Commands
WAVE:TRIGger:MODE
This command is used to set the trigger mode when take waveform as trigger
source.
Command syntax
WAVE:TRIGger:MODE <AUTO|NORMal|SINGle>
Arguments
AUTO|NORMal|SINGle
Query syntax
WAVE:TRIGger:MODE?
Returns
AUTO|NORMal
WAVE:TRIGger:MODE?
This command is used to query the trigger mode when take waveform as trigger
source.
Command syntax
WAVE:TRIGger:MODE?
Arguments
None
WAVE:TRIGger:SLOPe
This command is used to set trigger slope when takes waveform as trigger
source.
Command syntax
WAVE:TRIGger:SLOPe <POSitive|NEGative|ANY>
Arguments
POSitive|NEGative|ANY
Query syntax
WAVE:TRIGger:SLOPe?