ITech IT7600 Series

System Commands
Copyright© Itech Electronic Co., Ltd. 67
STEP:FREQ:STARt?
This command is used to query the starting frequency value.
Command syntax
STEP:FREQ:STARt?
Arguments
None
Returns
<float>
STEP:FREQ:STOP
This command is used to set the end frequency value.
Command syntax
STEP:FREQ:STOP <float>
Arguments
<float> float number of the end frequency value
Query syntax
STEP: FREQ:STOP?
Returns
<float>
STEP:FREQ:STOP?
This command is used to query the end frequency value.
Command syntax
STEP:FREQ:STOP?
Arguments
None
Returns
<float>
STEP:FREQ:INTErval
This command is used to set the STEP frequency step interval.