ITech IT7600 Series

System Commands
Copyright© Itech Electronic Co., Ltd. 24
SYSTem:SOURce:MODE
This command is used to set the source mode.
Command syntax
SYSTem:SOURce:MODE
Arguments
<SETUp/STEP/LIST>
Query syntax
SYSTem:SOURce:MODE?
Returns
<SETUp/STEP/LIST>
SYSTem:TRIG:SOURce
This command is used to set the trigger source type of system.
Command syntax
SYSTem:TRIG:SOURce
Arguments
<Key|SOFT|BUS|EXTernal>
Query syntax
SYSTem:TRIG:SOURce?
Returns
<Key|SOFT|BUS|EXTernal>
SYSTem:RUN:NETWork?
This command is used to query the current network status.
Command syntax
SYSTem:RUN:NETWork?
Arguments
None
Query syntax
SYSTem:RUN:NETWork?