ITech IT7600 Series

System Commands
Copyright© Itech Electronic Co., Ltd. 69
Command syntax
STEP:TIME:INTErval?
Arguments
None
Returns
<float>
STEP:PRIority<VOLT|FREQ>
This command is used to set STEP sweep priority (voltage priority or frequency
priority).
Command syntax
STEP:PRIority <VOLT|FREQ>
Arguments
<VOLT|FREQ>
VOLT: voltage priority
FREQ: frequency priority
Query syntax
STEP:PRIority? <VOLT|FREQ>
Returns
<VOLT|FREQ>
STEP:PRIority?
This command is used to query the STEP sweep priority (voltage priority or
frequency priority).
Command syntax
STEP:PRIority?
Arguments
None
Returns
<VOLT|FREQ>