ITech IT7600 Series

System Commands
Copyright© Itech Electronic Co., Ltd. 74
Returns
<float>
PROTect:PEAK:TIME
This command is used to set the delay time of peak protection current.
Command syntax
PROTect:PEAK:TIME <PARAllel|THREephase>,<float>
Arguments
Parameter 1：Device working mode
PARA,THREephase
Parameter 2：PEAK Current time
Query syntax
PROTect:PEAK:TIME? <PARAllel|THREephase>
Returns
<NRf>
PROTect:PEAK:TIME?
This command is used to query the delay time of peak protection current.
Command syntax
PROTect:PEAK:TIME? <PARAllel|THREephase>
Arguments
Parameter 1：Device working mode
PARA,THREephase
Returns
< float>
PROTect:PEAK:CTR
This command is used to set the control mode of peak protection current.
Command syntax
PROTect:PEAK:CTR<PARAllel|THREephase>,<IMME|TIME>
Arguments
Parameter 1：Device working mode