ITech IT7600 Series

System Commands
Copyright© Itech Electronic Co., Ltd. 61
Arguments
<A>
<float> Stopping angle (float value)
Query syntax
[SOURce:]NORMal:PHASe:STOP[:LEVel][:IMMediate]? <A>
Returns
<float>
[SOURce:]NORMal:PHASe:STOP:LIMit[:LEVel]
This command is used to set the maximum and minimum stopping angle of a
phase.
Command syntax
[SOURce:]NORMal:PHASe:STOP:LIMit[:LEVel]
<A>,<MINimum|MAXimum>,<float>
Arguments
<A>
<MINimum|MAXimum>
<float>
Query syntax
[SOURce:]NORMal:PHASe:STOP:LIMit[:LEVel]?
<A>,<MINimum|MAXimum>
Returns
<float>
[SOURce:]NORMal:MODE
This command is used to set the working mode of power supply.
Command syntax
[SOURce:]NORMal:MODE <A>,<AC|DC|ACDC>
Arguments
<A>
<AC|DC|ACDC> working mode
Query syntax
[SOURce:]NORMal:MODE? <A>