System Commands
Copyright© Itech Electronic Co., Ltd. 86
Command syntax
*OPC?
Arguments
None
Returns
1
*RST
This command resets the frequency to 50 and other parameters to 0 of AC
power supply in the setup mode and meter mode.
Command syntax
*RST
Arguments
None
*SRE
This command sets the condition of the Status Request Enable Register.After
executing this command, AC power supply will return back a decimal value
which is a binary weighted sum of all bits from the enable register.
Command syntax
*SRE <value>
Arguments
0～255
Default set
Refer to *PSC command
Example
*SRE 128
Query syntax
*SRE?
Returns
<value>
To Next Page
Loading...
