ITech IT7600 Series

System Commands
Copyright© Itech Electronic Co., Ltd. 44
WAVE:SINGle
This command is used to set the single mode to start waveform capture.
Command syntax
WAVE:SINGLe
Arguments
None
Query syntax
None
WAVE:RUN
This command is used to start waveform capture.
Command syntax
WAVE:RUN
Arguments
None
Query syntax
None
WAVE:STOP
This command can stop the waveform capture.
Command syntax
WAVE:STOP
Arguments
None
Query syntax
None
WAVE:TRIGger[:STATe]?
This command is used to query the trigger status.