ITech IT7600 Series

System Commands
Copyright© Itech Electronic Co., Ltd. 66
STEP:MODE
This command is used to set the STEP working mode.
Command syntax
STEP:MODE <TIME|TRIG >
Arguments
<TIME|TRIG >
TIME: Time sweep mode
TRIG: Trigger sweep mode
Query syntax
STEP:MODE?
Returns
<TIME|TRIG >
STEP:MODE?
This command is used to query the STEP working mode.
Command syntax
STEP:MODE?
Arguments
None
Returns
<TIME|TRIG >
STEP:FREQ:STARt
This command is used to set the starting frequency value.
Command syntax
STEP:FREQ:STARt <float>
Arguments
<float> float number of the starting frequency value
Query syntax
STEP:FREQ:STARt?
Returns
<float>