IT7600 Programming Guide
Copyright© Itech Electronic Co., Ltd. iii
Environmental Conditions
The instrument is designed for indoor use and an area with low condensation.
The table below shows the general environmental requirements for the
instrument.
20%～80%( non-condensation)
Operating up to 2,000 meters
Note
To make accurate measurements, allow the instrument to warm up for 30 min.
Regulatory Markings
The CE mark indicates that the
product complies with all the relevant
European legal directives. The specific
year ( if any) affixed refers to the year
when the design was approved.
The instrument complies with the
WEEE Directive ( 2002/96/EC)
marking requirement. This affix
product label indicates that you must
not discard the electrical/electronic
product in domestic household waste.
This symbol indicates the time period
during which no hazardous or toxic
substances are expected to leak or
deteriorate during normal use. The
expected useful life of the product is
10 years. The product can be used
safely during the 10-year Environment
Friendly Use Period ( EFUP). Upon
expiration of the EFUP, the product
must be immediately recycled.
Waste Electrical and Electronic Equipment ( WEEE)
Directive
2002/96/EC Waste Electrical and Electronic Equipment
( WEEE) Directive
This product complies with the WEEE Directive
( 2002/96/EC) marking requirement. This affix product label
indicates that you must not discard the electrical/electronic
product in domestic household waste.
To Next Page
Loading...
