ITech IT7600 Series

System Commands
Copyright© Itech Electronic Co., Ltd. 59
Returns
<float>
[SOURce:]NORMal:FREQuency[:LEVel][:IMMediate]
This command is used to set the frequency of a phase.
Command syntax
[SOURce:]NORMal:FREQuency[:LEVel][:IMMediate]
<A>,<float>
Arguments
<A>
<float> frequency
Query syntax
[SOURce:]NORMal:FREQuency[:LEVel][:IMMediate]? <A>
Returns
<float>
[SOURce:]NORMal:FREQuency:LIMit[:LEVel]
This command is used to set the maximum and minimum frequency.
Command syntax
[SOURce:]NORMal:FREQuency:LIMit[:LEVel]
<A>,<MINimum|MAXimum>,<float>
Arguments
<A>
<MINimum|MAXimum>
<float>
Query syntax
[SOURce:]NORMal:FREQuency:LIMit[:LEVel]?
<A|B|C|ALL>,<MINimum|MAXimum>
Returns
<float>
[SOURce:]NORMal:PHASe:STARt[:LEVel][:IMMediate]
This command is used to set the starting angle of a phase.