ITech IT7600 Series

System Commands
Copyright© Itech Electronic Co., Ltd. 64
Chapter9 STEP Commands
STEP:VOLTage:STARt
This command is used to set the starting voltage value.
Command syntax
STEP:VOLTage:STARt <float>
Arguments
<float> float number of the starting voltage value
Query syntax
STEP:VOLTage:STARt?
Returns
<float>
STEP:VOLTage:STARt?
This command is used to query the starting voltage value.
Command syntax
STEP:VOLTage:STARt?
Arguments
None
Returns
<float>
STEP:VOLTage:STOP
This command is used to set the end voltage value.
Command syntax
STEP:VOLTage:STOP <float>
Arguments
<float> float number of the end voltage value
Query syntax
STEP:VOLTage:STOP?