ITech IT7600 Series

System Commands
Copyright© Itech Electronic Co., Ltd. 42
Query syntax
WAVE:TRIGger:CURRent[:LEVel]?
Returns
<value>
WAVE:TRIGger:CURRent[:LEVel]?
This command is used to query the current trigger level
Command syntax
WAVE:TRIGger:CURRent[:LEVel]?
Arguments
None
WAVE:TRIGger:DELay:TIME
This command is used to set the trigger delay time when take a waveform as
trigger source.(Note:the delay time setting should be less than the time width of
the whole screen).
Command syntax
WAVE:TRIGger:DELay:TIME <float>
Arguments
<float>
Unit
s
Query syntax
WAVE:TRIGger:DELay:TIME?
Returns
<float>
WAVE:TRIGger:DELay:TIME?
This command is used to query the trigger delay time when take a waveform as
trigger source.(Note:the delay time setting should be less than the time width of
the whole screen).