System Commands
Copyright© Itech Electronic Co., Ltd. 71
Chapter10 Protection commands
PROTect:RMS:CURRent
This command is used to set the RMS protection current.
Command syntax
PROT
ect:RMS:CURR
ent <P
ARAllel|TH
REephase>,<float>
Arguments
Parameter 1<PARAllel|THREephase>：Device working mode
PARAllel,HREephase
Parameter 2<float>：Current rms
Query syntax
PROT
ect:RMS:CURR
ent? <P
ARAllel|TH
REephase>
Returns
<float>
PROTect:RMS:CURRent?
This command is used to query the RMS protection current.
Command syntax
PROT
ect:RMS:CURR
ent? <P
ARAllel|TH
REephase>
Arguments
Parameter 1<PARAllel|THREephase>：Device working mode
PARAllel,THREephase
Returns
<float>
PROTect:RMS:TIME
This command is used to set the delay time of RMS protection current.
Command syntax
PROT
ect:RMS:TIME <P
ARAllel|THR
Eephase>,<float>
Arguments
Parameter 1：Device working mode
To Next Page
Loading...
