Operation
Drive Controls, Switches and Instruments
38 38
9811-3400-4
Transmission
Forward/Reverse Lever and Transmission Control
S240120-10
Fig 23.
To select a gear, turn the barrel (+/-) on the lever so that the
arrow marked on the barrel aligns with the required gear.
The gear ratio allocated to each of the positions on the
column switch is dependant on the transmission mode that
is selected. Refer to Transmission Modes.
To select a drive direction move the lever to the required
position.
To prevent the accidental operation of the forward/reverse
lever, the lever may be locked in the neutral position.
K
Neutral Lock ( T 61).
Forward/Reverse Switch
The forward/reverse switch A is used to control the
direction of the machine as an alternative to the forward/
reverse lever.
To select a drive direction move the switch to the required
position.
!MCAUTION
Do not operate the Forward/Reverse switch when
already using the Forward/Reverse lever, otherwise
the transmission will select neutral. When using the
Forward/Reverse switch, the Forward/Reverse lever
MUST be locked in neutral.
4-2-1-6_2
806580-3
Fig 24. Multi-controls lever
806580-2
Fig 25. Servo-controls lever
F Forward
N Neutral
R Reverse
+/- Gear selection
F/N/R Drive selection
X K
Transmission Kickdown Switch ( T 42)
To Next Page
Loading...
