Operation
Drive Controls, Switches and Instruments
39 39
9811-3400-4
Drive Selection
!MWARNING
You and others can be killed or injured if you operate
the forward/reverse lever while you travel. The
machine will immediately reverse direction without
warning to others. Follow the recommended
procedure for proper use of this selector.
2-2-2-4_2
!MWARNING
Travelling at High Speeds
Travelling at high speeds can cause accidents. Do not
reverse in a high gear with full throttle. Always travel
at a safe speed to suit working conditions.
INT-5-3-3
The machine can be moved off in any gear, dependant on
the ground conditions.
When the machine is stationary before a gear is selected,
make sure that:
– The forward/reverse lever and switch are in the
neutral (N) position. (The engine will only start if the
transmission is in neutral).
– The engine is at idle speed.
Stop the machine before the transmission is changed from
forward to reverse or reverse to forward drive.
To select forward (F), reverse (R) or neutral (N) drive,
move the forward/reverse lever or switch to the required
position.
To reverse direction:
1 Release the throttle pedal.
2 Push the foot brake to stop the machine, keep the foot
brake applied.
3 Move the move the forward/reverse lever or switch to
the new drive direction.
4 Release the foot brake and accelerate away.
To Next Page
Loading...
