Эксплуатация – АВТОМАТИЧЕСКИЙ РЕЖИМ "PROFILING"
Operation - AUTOMATIC “PROFILING”
F2 – ИЗМЕНЕНИЕ РАСПОЛОЖЕНИЯ:
Laser Pointer (Рис.
7-24) F2,
.
( ),
:
F2 Laser
Pointer (1, Рис. 7-25).
.
F2 Laser
Pointer, .
Примечание:
.
, (
) ,
Примечание:
.
.
F2 - POSITION CHANGE:
With the Laser Pointer mode active (Fig. 7-24), the F2
key opens the Menu with the Item used to change the
weight position during the application phase.
Once you have reached the adhesive weight application
position (green arrows), change the weight position as
follows:
Press the F2 key in the Menu and select Laser Pointer
(1, Fig. 7-25)..
Manually rotate the wheel to change the position of the
weight indicated by the pointer.
Press the F2 key in the Menu and select Laser Pointer
to enter the position reached.
Note:
The relocation causes a variation of the position and
value of both weights. As the change can be performed
on both planes, the right weight (close to the rim
flange) is usually applied first, due to the fact that it
needs to be moved more often.
Note:
The change in the position of the weight is saved by
the machine, then automatically suggested for all
subsequent wheels with the same dimensions. The
selection is deleted when the machine is switched off.
To Next Page
Loading...