Эксплуатация – АВТОМАТИЧЕСКИЙ РЕЖИМ OPTIMA
Operation - AUTOMATIC “OPTIMA”
7.10.8 Отслеживание грузов
OPTIMA PROFILING
.
,
(Power
Clamp).
.
:
.
.
.
.
(4, Рис. 7.47):
Enabled» в пункте меню
Measurements Settings / Weight usage tracking
OK.
F2 (1, Рис. 7-80).
:
(Рис. 7-81)
F2:
F3:
(a) (b)
F6: .
Примечание: F6
.
7.10.8 Weight usage tracking
The Weight Tracking function is available in OPTIMA and
PROFILING modes and is for saving data relative to wheel
imbalances, or the weight mode and the weights indicated
for balancing.
Saves the data acquired at the first run, after clamping
the wheel on the balancer shaft (Power Clamp activation).
This data is effectively acquired in the memory at the
moment when the wheel is released.
This function shows the count of all balancing weights
used up to that moment and provides a printed report on
the following options:
Weights Used in Grams, from the date of function
installation.
Weights Used in Ounces, from the date of function
installation.
Weights Used in Grams, from the date of user zeroing
of the Weight Tracking Counter.
Weights Used in Ounces, from the date of user zeroing
of the Weight Tracking Counter.
To enable the function access the screen
(4, Fig. 7.47) and select the following:
Measurements Settings / Weight usage tracking
set Enabled and press OK.
The Weight Tracking screen page is retrieved from the
FUNCTION screen page using the F2 key (1, Fig. 7-80).
In the WEIGHT TRACKING screen page:
(Fig. 7-81)
F2: zeroes the partial table counters
F3: to switch from the Partial Table to the Total Table
(a) and vice versa (b)
F6: prints the Table currently on screen.
Note: key F6 is only visible if the printer is enabled.
To Next Page
Loading...