Ежедневно:
Конусы и зажимные приспособления
.
:
•
.
•
;
.
•
.
.
13.2 Смена предохранителей сети питания
. . 13-2.
•
.
•
.
•
.
•
(2).
•
.
•
.
13.2.1 Послепродажное обслуживание
.
:
http://www .snaponequipment.com/johnbean
Snap-on Equipment SrL
Via Per Carpi 33
42015 Correggio RE - Italy
Every Day:
Cones and Wheel clamping parts
At the end of every working day, after switching off the
machine, clean the clamping cones and the Power Clamp
lock nut, as well as any special Flanges used, and return
to their positions.
Perform the following maintenance operations:
Clean only with a clean, dry and soft cloth.
Check the mechanical conditions; the parts must not
have any abrasions, dents or incisions.
Check the wear conditions and, if necessary, clean
the wheel clamping shaft and the relative cone clamping
ratchets.
If there are any permanent faults, consult the Customer
Technical Support service.
13.2 Changing the mains fuse
Refer to Figure 13-2.
Switch off the unit.
Unplug the power cable from the power outlet.
Remove the power cable from the machine mains
socket.
Pull out the fuse holder (2).
Replace the damaged fuse with another fuse having
an identical rating.
Return the unit to its original functioning state, by
following the steps above in reverse.
13.2.1 After-sales service
Contact your area agent.
The company website provides information about the
Customer Assistance service around the world:
http://www .snaponequipment.com/johnbean
Manufacturing Facility
Snap-on Equipment SrL
Via Per Carpi 33
42015 Correggio RE - Italy
To Next Page
Loading...