Эксплуатация – АВТОМАТИЧЕСКИЙ РЕЖИМ OPTIMA
Operation - AUTOMATIC “OPTIMA”
7.10.1 Измерительный цикл в режиме OPTIMA
.
START:
Рис. 7-46.
; ;
.
Optima.
:
F1
(1, Рис. 7-47).
.
F1
(2, Рис. 7-47).
.
F2 (Рис 7-48)
(ALU):
.
:
F5
(Рис. 7-49).
OPTIMA :
F1
OPTIMA ENTRY (1, Рис. 7-50).
7.10.1 Wheel measuring run in OPTIMA Mode
Lower the covering guard. If the automatic measuring
run function has not been activated, press the START
key: the balancer carries out the wheel measuring run
piloted by the Cameras Figure 7-46. They detect the
rim profile; measure the wheel runout; the internal rim
lateral and radial and the external rim lateral and radial.
At the end of the wheel measuring run the balancer
displays any unbalance on the wheel and signals the
points to fit the weights, unless the RUNOUT limits
have not been exceeded, in this case the balancer
automatically suggests the display of the Optima
diagnostic results.
To go back to the basic balancing screens:
Press F1 and select Balancing (1, Fig. 7-47).
The values will be displayed along with the weight
application positions.
Press F1 and select Rim Data (2, Fig. 7-47).
The wheel (rim + tire) size data detected with the wheel
measuring run will be displayed.
Press F2 and select an Item (Figure 7-48).
To change the weight application characteristic (ALU):
the balancer will automatically recalculate the value and
position of the corresponding weights.
The wheel measuring run may have detected the number
of spokes:
Press F5 to start the Weights behind the Spokes
positioning procedure (Fig. 7-49).
To access the results of the OPTIMA diagnosis, from
one of the basic screens:
Select in the F1 Menu the OPTIMA ENTRY item
(1, Fig. 7-50).
To Next Page
Loading...