Балансировка и установка грузов
Balancing and weights Fitting
8. Балансировка
:
( 6.4).
( 6.5).
( 7.1.1).
( 7.2).
.
.
:
• F1
(1, Рис. 8-1).
(Рис. 8.2).
Рис. 8-2
:
F1 .
F2 ALU.
F3 .
F4 :
/
()
F5
F6 .
8.1 Определение величины дисбаланса
:
•
START.
(Рис. 8-3).
.
,
(1, Рис. 8-3).
.
.
8. Balancing
Preliminary operations:
If necessary, perform a compensation run(Section 6.4).
Check the wheel is clamped correctly (Section 6.5).
Select the Type of Vehicle (Section 7.1.1).
Read the rim dimension parameters (Chapter 7.2).
If more than one wheel of the same type needs to be
balanced (the same nominal dimensions) the data need
only be set for the first wheel. The selections stay set
until other new data is set or the machine is switched off.
To access the BALANCING screen:
• Press the F1 Menu Key and select the Balancing item
(1, Fig. 8-1).
The BALANCING screen (Figure 8.2) will open.
Fig. 8-2 BALANCING
Menu key details:
F1 Contains the different screen access options.
F2 Contains the ALU Type selection options.
F3 Contains the Type of Vehicle selection options.
F4 Contains the setting options for:
Static Imbalance
End of weight reading
Grams / Ounces
Weight Miser (if included)
F5 Not active
F6 Contains the COMPENSATION RUN option.
8.1 Measuring imbalance
Having completed the preliminary operations, a Measuring
run can be launched:
• Close the wheel guard and press the START key.
The BALANCING screen appears (Fig. 8-3).
After measurement the balance weights can be fitted, or
a weight minimisation or optimisation run can be carried
out. The specific icon (1, Fig. 8-3), indicates that the
machine suggests a weight Optimisation or Minimisation
procedure is carried out.
After measurement the machine stops automatically
and the wheel is braked such that the weight for the
left (Factory selection) correction plane can be fitted
exactly perpendicular to and above the main shaft.
The screen shows the unbalance measured for each
correction plane and the direction towards correction.
To Next Page
Loading...