Эксплуатация – АВТОМАТИЧЕСКИЙ РЕЖИМ OPTIMA
Operation - AUTOMATIC “OPTIMA”
7.10 Режим OPTIMA
OPTIMA.
. 7-33 OPTIMA
.
.
OPTIMA
-
.
.
. 4 "".
.
. 7-34).
. 7-35,
:
- ()
- ( )
,
(1, Рис. 7-36).
,
рис. 7-35а.
.
Примечание:
.
.
Примечание:
,
OPTIMA
:
( 7.8)
Блокировка данных колеса ( 7.8.1).
( 7.9).
.
7.10 "OPTIMA" Mode
The following instructions describe the specific functions
of the wheel balancer in OPTIMA mode.
The icon shown in fig. 7-33 indicates the PROFILING mode
is active. The unit operates in Automatic Mode.
When the "OPTIMA" mode is set with the set up panel,
the machine performs the automatic wheel data reading
procedure and the user does not have to perform any
setting before the measuring run.
This section sets out the specific functions of the
"OPTIMA" mode and only the Menu items that refer to
this mode.
For information about the other items and icons, refer to
the basic chapter "4. Control Elements".
The balancer displays the start screen at power-on.
The screen in fig. 7-34 appears automatically on the monitor
after clamping the wheel.
During the wheel measuring run the screen in fig. 7-35
appears and at the end the weights shown can be:
- suggested (yellow)
or
- possible alternatives (grey) in the 6 o-clock zone, precisely
where the laser beam indicates they should be applied
(1, Fig. 7-36).
If the Spokes Count is active, the icon in figura (Fig. 7-
35a) is displayed during the measuring run.
The possible application of the weights in ways other than
that suggested by the machine is indicated by the grey
weights in the positions compatible with the rim
configuration detected.
Note:
The change in the position of the weight is saved by the
machine, then automatically suggested for all
subsequent wheels with the same dimensions. The
selection is deleted when the machine is switched off.
Note:
As far all the Automatic Modes, the previously
described functions can also be used in the OPTIMA
Mode:
ATION (section 7.8)
Rim Data Freeze (section 7.8.1).
Spokes (section 7.9).
Further Menu Items and specifications of this mode are
described below.
To Next Page
Loading...